U1266 ошибка ниссан лиф

Newporttom wrote:Replacement battery pack with 35,000 miles on it. No lost bars yet. 12v battery might be 18 months old. Have one of the modified EVES that allows you to do 240.

Got home with 9 miles left and LBW. Plugged it in. Paid no attention to whether charging lights came on. Leaf Spy with newer ELM device was on all night I think.

Today car won’t start. No indications of charge bars (had one when I got home). Car acts like it’s on but shows 0 bars of charge. Car beeps when you plug in EVSE but no lights come on (even for a second).

DTS codes
P317 00C0 EV/HEV Restart Inhibition EVC-310
PA0AA6 00C6 EV/Hev Hybrid Batt Volt Sys Isolation EVC-157

U1266 0208 Multi AV TCU Conn AV-92
U1232 0108 Multi AV St ANgle Sen Calib AV-88

Didn’t see anything quite like this when searching. Car reads as being in Neutral but not sure if it really is.

U1266 0208 Multi AV TCU Conn AV-92
This code means that the TCU (Carwings) unit was disabled. I’m guessing you still have the old 2G TCU, didn’t pay for the upgraded 3G model. If so, congratulations—the dealer did the service properly (I had 3 dealers attempt and fail this). You can ignore this code, it has nothing to do with your problem and this code is not a problem as long as you don’t use Carwings.

U1232 0108 Multi AV St ANgle Sen Calib AV-88
http://www.mynissanleaf.com/viewtopic.php?t=16777

This code appears to have been related to the steering wheel angle calibration sensor. If you turn the wheel left and right, it should clear the error condition. This is also linked to 12V battery issues. See here:
http://www.mynissanleaf.com/viewtopic.php?t=16777

P317 00C0 EV/HEV Restart Inhibition EVC-310
PA0AA6 00C6 EV/Hev Hybrid Batt Volt Sys Isolation EVC-157

Do you have typos in these codes? I see on another page them described as follows
P31E7 000B EV/HEV Restart Inhibition EVC-310
P0AA6 0008 EV/HEV Hybrid Batt Volt Sys Isolation EVC-157
(http://www.mynissanleaf.com/viewtopic.php?t=26179)

These indicate one of two things:
1) Your 12V battery is low or dead and causing the car to misdiagnose things. This is supported by the U1232 error as well. OR
2) Your main traction battery has gone bad, one of the cells has failed.

This is what you should do:
1) Put a standard car battery charger on the 12V battery under the hood, as alozzy suggested. Let it charge until the 12V battery is charged. You can use any 12V car battery charger like you would have for a gas-powered vehicle.
2) Clear the codes with LeafSpy Pro
3) Try to turn the car on and start it. If it starts, recheck codes with LeafSpy and verify that none are present, other than the TCU Conn. If the Angle Sen code is still present, turn the steering wheel right and left, re-clear and check codes
4) If the car still will not start, schedule a dealer repair visit. Your main traction (high voltage) battery has detected a fault and shut off. This should be covered by the 8 year 100k mile warranty. While they may just repair the one failing cell, you will most likely get a new battery (and factory fresh, 2012 range). Celebrate!

What I would NOT do is: Trade in the car at the dealership as a non-running vehicle to avoid the hassle. You have a very good shot of having a brand new battery from Nissan which will make the car more valuable.

Hope your wife loves her new Leaf, whenever she does get it!

Ошибки топливно-воздушной системы Nissan Leaf

Ошибки системы зажигания Nissan Leaf

Ошибки выпускной системы Nissan Leaf

Ошибки систем силовых агрегатов Nissan Leaf

Ошибки трансмиссии Nissan Leaf

Ошибки систем управления гибридной установкой Nissan Leaf

Ошибки тормозной системы и систем контроля тяги Nissan Leaf

Ошибки систем кузова Nissan Leaf

Ошибки связи систем управления Nissan Leaf

Найдена следующая информация по ошибке U1266 для автомобиля NISSAN LEAF (2010-2017):

На русском языке:

Это не часто встречающаяся неисправность в электрической цепи двигателя или автоматической коробки передач, вероятнее всего специфическая для Вашей марки автомобиля.

На английском языке:

OBD2 not find in catalog.

Вы можете задать вопрос или поделиться опытом устранения ошибки U1266 на автомобиле NISSAN с другими пользователями.

Возможную причину возникновения и советы по устранению можно найти в каталоге причин и советов:

Найти причину   >>> 

Ошибки (коды ошибок) полученные от прибора, сканера требуют правильной интерпретации информации, дабы не тратить время и деньги на замену работающих элементов автомобиля.

Проблема зачастую кроется намного глубже чем кажется на первый взгляд. Это& вызвано теми обстоятельствами, что информационные сообщения содержат, как было выше сказано, косвенную информацию о нарушении работы системы.

Может быть полезным для решения вопроса по устранению неисправности у Nissan Leaf:

С учетом редкости и неоднозначности данной ошибки, мы не можем найти конкретный исчерпывающий ответ на вопрос причины возникновения неисправности.

Данная ошибка является специфичной для Вашей марки автомобиля, рекомендуем, либо обратиться на специализированный автосервис .

AV

U1263 USB

AV-287

< DTC/CIRCUIT DIAGNOSIS >

[NAVIGATION WITHOUT BOSE]

C

D

E

F

G

H

I

J

K

L

M

B

A

O

P

U1263 USB

DTC Logic

INFOID:0000000010122558

DTC DETECTION LOGIC

NOTE:

Before performing the diagnosis, be sure to check that the external input device has no malfunction.

Diagnosis Procedure

INFOID:0000000010122559

1.

CHECK USB HARNESS

Check the USB harness visually and check if there is any pinching.
Is the check result normal?

YES

>> Replace the AV control unit. Refer to

AV-318, «Removal and Installation»

.

NO

>> Replace the USB harness. Refer to

AV-329, «Removal and Installation»

.

DTC

Display contents of CON-

SULT

Malfunction detection condition

Action to take

U1263

USB overcurrent
[U1263]

Overcurrent of the USB connector is detected.

Check the USB harness be-
tween the AV control unit
and USB connector.

AV-288

< DTC/CIRCUIT DIAGNOSIS >

[NAVIGATION WITHOUT BOSE]

U1266 AV CONTROL UNIT

U1266 AV CONTROL UNIT

DTC Logic

INFOID:0000000010122560

DTC

Display contents of CON-

SULT

DTC detection condition

Action to take

U1266

TCU CONN
[U1266]

Malfunction is detected between the AV control unit and
TCU.

Check the connection be-
tween the AV control unit and
TCU.

AV

U1300 AV COMM CIRCUIT

AV-289

< DTC/CIRCUIT DIAGNOSIS >

[NAVIGATION WITHOUT BOSE]

C

D

E

F

G

H

I

J

K

L

M

B

A

O

P

U1300 AV COMM CIRCUIT

Description

INFOID:0000000010122561

U1300 is displayed when the AV signal error is detected for the multi AV system. It is always displayed

together with the error of the control unit connected to the AV control unit via AV communication. Determine

the possible malfunction cause from the table below.

SELF-DIAGNOSIS RESULTS DISPLAY ITEM

DTC

Display contents of CONSULT

Description

Probable malfunction location

U1300
U1240

• AV COMM CIRCUIT [U1300]
• SWITCH CONN [U1240]

When either one of the following items
are detected:
• multifunction switch power supply and

ground circuits are malfunctioning.

• AV communication circuits between

the AV control unit and multifunction
switch are malfunctioning.

• Multifunction switch power supply

and ground circuits.

• AV communication circuits be-

tween AV control unit and multi-
function switch.

AV-290

< DTC/CIRCUIT DIAGNOSIS >

[NAVIGATION WITHOUT BOSE]

U1310 AV CONTROL UNIT

U1310 AV CONTROL UNIT

DTC Logic

INFOID:0000000010122562

DTC

Display contents of

CONSULT

DTC detection condition

Action to take

U1310

CONTROL UNIT (AV)
[U1310]

AV communication circuit initial diagnosis malfunction is
detected

Replace the AV control unit if the
malfunction constantly occurs. Refer
to

AV-318, «Removal and Installa-

tion»

.