Safeguard ошибка на опель вектра

• Здравствуйте.
  Данная ошибка свидетельствует о неисправности систем безопасности. К ним прежде всего относятся подушки безопасности. Наиболее вероятно причина возникновения ошибки плохой контакт или неисправность проводки или датчика подушек безопасности. В данном случае необходимо провести компьютерную диагностику- она покажет точную причину возникновения данной ошибки. Просто сбросить ошибку вероятнее всего не удастся.

  Россия, Subaru Legacy

• A samostojateljno Ja smog bi ubratj eti owibku bez kompjuternoj diagnostiki

  Великобритания, Opel Vectra

• Самостоятельно сбросить ошибку можно попробовать отсоединив примерно на минуту аккумулятор, но вероятнее всего ошибка возникнет снова, так как необходимо выявить причину ее возникновения данной ошибки. Эта ошибка носит не идиновременный характер.

  Россия, Subaru Legacy

• Спасибо макс

  Великобритания, Opel Vectra

• Спасибо макс

  Великобритания, Opel Vectra

• Обращайтесь.
  Всегда рады ответить на все интересующие Вас вопросы.

  Россия, Subaru Legacy

1. 18th March 2021, 13:57

   
   

   #1

   

   
   New Member
   

   

   ---

   hello

   I hope someone can help with this problem.

   I recently purchased a 56 Reg Vectra c 2.2 Elite Auto.

   Every time I start the car I get safeguard Check appear on the display, until I press the button to get rid of it. The alarm works fine although a little quiet. I sat in the car pressed the interior sensor button and moved about to trigger alarm, which worked.

   If I unlock the door with a key, as sometimes I have to reset the key, the alarm goes off until I put the key in the ignition.

   Is there anything else I should be checking to see why I am getting Safeguard Check, on the display, is this a Fuse thing or a wiring thing.

   Also sometimes I have a fault with locking the car. I press lock on the key fob and all doors are locked, then I press lock again on fob to deadlock, and nothing happens. I then try to unlock car by the fob, and nothing happens, I have to unlock the car manually, which triggers the alarm, I then have to put key in the ignition to turn alarm off, after this the key fob works fine. I can lock and then dead lock. This fault occurs intermittently. I have changed the batteries on both key fobs, and I tried both key fobs when this fault occurs, as I thought it might be a key fob thing.

   Any advise

   Thanks

   ---

2. 18th March 2021, 14:11

   
   

   #2

   
   

   The little running man on centre dash is to cancel motion sensor in car is for when you have kids/animals in same thing really in the car.
   If est as rear quarter glass wiring fails or roof ribbon breaks.
   Read codes just clear first then restart to see what comes up, and go from there.

   ​​​VECTRA VXR�s BOTH TEAPOT TUNED WITH A LITTLE OLD DOGGIE TWEAK.
   TECH2WIN AND GDS2 2023 DIAGNOSTICS.
   PIN RETRIEVAL FROM SOME MODULES.

   ---

3. Post Thanks / Like — 1 Thanks, 0 Likes

   

   Guggsy thanked for this post

4. 18th March 2021, 15:04

   
   

   #3

   

   
   New Member
   

   

   ---

   
   

   Originally Posted by Jon1796
   

   The little running man on centre dash is to cancel motion sensor in car is for when you have kids/animals in same thing really in the car.
   If est as rear quarter glass wiring fails or roof ribbon breaks.
   Read codes just clear first then restart to see what comes up, and go from there.

   So is there anyway to test the ribbon cable in the roof to see if it is broken. Or would it be easier to plug in a diagnostic tool turn on ignition and see which error comes up.

   ---

5. 18th March 2021, 18:51

   
   

   #4

   
   

   Have you read all the other threads about safe guard check and estates on the forum?

   Vectra VXR estate 2007 Sapphire Black
   Teapot Tuned 255/300
   Eibachs B8’s, fully loaded factory options

   Tech2 & MDI diagnostics + SPS

   ---

6. 18th March 2021, 19:02

   
   

   #5

   

   
   New Member
   

   

   ---

   
   

   Originally Posted by Dog_Book
   

   Have you read all the other threads about safe guard check and estates on the forum?

   Yes i have previously, checking ribbon cables and the ultrasonic sensors, and certain fuses. I know the ultrasonic sensors work due to the fact, i sat in the car pressed the button on the centre console, and triggered the alarm after moving. only thing i haven’t done yet is to check the fuses. The red LED flashes as supposed to when you lock the carlong flashes then after a certain time short burst flashes. My only question is if a fuse has blown, would the alarm work at all.

   ---

7. 18th March 2021, 20:06

   
   

   #6

   
   

   Plug in diagnostics see what comes up.
   is it hatch or est ?
   Are you sure you tested sonic’s if you sit in locked car not pressing little man, move about wave hands it’ll go off, press little man lock you can wave as much as you like will not go off.

   ​​​VECTRA VXR�s BOTH TEAPOT TUNED WITH A LITTLE OLD DOGGIE TWEAK.
   TECH2WIN AND GDS2 2023 DIAGNOSTICS.
   PIN RETRIEVAL FROM SOME MODULES.

   ---

8. 18th March 2021, 23:05

   
   

   #7

   

   
   New Member
   

   

   ---

   
   

   Originally Posted by Jon1796
   

   Plug in diagnostics see what comes up.
   is it hatch or est ?
   Are you sure you tested sonic�s if you sit in locked car not pressing little man, move about wave hands it�ll go off, press little man lock you can wave as much as you like will not go off.

   When i tested it, i locked the car and pressed the little man, i moved about and alarm went off, with me sitting in drive seat. When i pressed little man, the red LED flashes then goes into short burst flashes, I then moved to trigger alarm. I didn’t know you can trigger alarm by just sitting in locked car without pressing little man.

   BTW it is a hatch

   ---

9. 19th March 2021, 12:46

   
   

   #8

   
   

   Pressing the little man turns off sonics, so if you have kids etc open windows when you lock it alarm won’t go off. If you say you sat in car and alarm went off then shows sonics work and ribbon should be ok he says. So that means another fault, cheapest option for diagnostics is o.c/v.c just get one with out c22/d5 parts.

   ​​​VECTRA VXR�s BOTH TEAPOT TUNED WITH A LITTLE OLD DOGGIE TWEAK.
   TECH2WIN AND GDS2 2023 DIAGNOSTICS.
   PIN RETRIEVAL FROM SOME MODULES.

   ---

10. 19th March 2021, 18:39

    
    

    #9

    Vectra VXR estate 2007 Sapphire Black
    Teapot Tuned 255/300
    Eibachs B8’s, fully loaded factory options

    Tech2 & MDI diagnostics + SPS

    ---

11. 19th March 2021, 19:52

    
    

    #10

    

    
    New Member
    

    

    ---

    
    

    Originally Posted by Jon1796
    

    Pressing the little man turns off sonics, so if you have kids etc open windows when you lock it alarm won’t go off. If you say you sat in car and alarm went off then shows sonics work and ribbon should be ok he says. So that means another fault, cheapest option for diagnostics is o.c/v.c just get one with out c22/d5 parts.

    So i borrowed my mates diagnostic tool and saw the error codes, although i can’t remember the error code numbers, but 1st code was mentioning about the siren, and the second code was about rearview mirror tilt. i should have noted the codes.

    ---

Hi Jane, I’ve just done a google search, and its coming up as a fault with the alarm system.

Has the alarm been set off recently? Also the page i found is saying that if there is a light blinking, it’s indicating what to check.

If the light blinks for the first 10 seconds, it’s indicating door/bonnet/boot is open, or a system fault. 

It also mentions about some wires behind the rear view mirror, these might have been detached from the ultra sonic sensors, also near the rear view mirror. 

There is also a link to show how to check these wires. 

http://forum.vectra-c.com/showthread.php?t=29944

Hope this helps, and please let us all know how it goes. If it works, then it is something to pass onto other Vectra owners. 

Regards Andy R.